Router Forums - Reply to Topic
Thread: HDS's Jewellery Box Reply to Thread
Title:
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now



In order to be able to post messages on the Router Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
12-18-2017 11:27 PM
RainMan 2.0 Nice job Henry. I want to learn how to make one myself someday
12-18-2017 11:09 PM
A-1jim Impressive first box great job.
02-10-2010 02:26 AM
Dr.Zook Very nice Henry. A job well done.



02-10-2010 12:52 AM
woodstover Beautiful job, she is a lucky girl!
02-10-2010 12:38 AM
CanuckGal Henry I think that's quite an accomplishment for a first box! It's simply beautiful. I really like the polished finish! Well done indeed!
02-09-2010 10:08 AM
HDS
HDS's Jewellery Box

English Jewellery box. ZZZzzz!

Attachment 32830

Attachment 32831

Attachment 32832

Attachment 32833

Attachment 32834

Attachment 32835

Attachment 32836

Attachment 32837

Attachment 32838

Well I finally got round to putting what few pictures I had left of the project. (Since changing my phone in early January, I had to transfer pics from the old phone).
Our young friend got it for a Christmas prezzie for her Tiffany's silver collection! (Lucky girl).

I started with some scraps of Mahogany and Ash I had lying around.

The boards I thicknessed to 3/8" and T&G on my router table and Jointed to make the 10" x 6" x 5 1/2" sides top and bottom.

I bevelled the inside ends of the boards with a 45 degree chamfer bit again at the router table. On the opposite side, ie outsides, I routed 3/4" wide by 1/4" deep rabbets for the corner post recesses.

The Ash corner posts made from 1" square section I routed deep Rabbets to get an L , (Angle) section with 1/4" thick walls.

The tray and tray supports were made up in a similar way to the box in Mahogany, with Ash dividers.

The whole lot glued up then sanded by hand to a fine flush finish.
I finished with a coat of linseed oil followed after a couple of days drying by sanding sealer and then clear french polished to a fine full grain finish.

Next, I cut 1/4" wide 1/8" deep slots about 3/8" from the top inside edges of the box and lid to allow tucking the frayed edge of the lining material, which was cut in one piece in situ and glued directly to the inside walls of the box and lid.
Last of all routed morticing for the hinges and catch fittings. (Squaring the corners by hand chisel).

This was my first box, hence the simple design.

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

 
For the best viewing experience please update your browser to Google Chrome