Router Forums - Reply to Topic
Thread: Jammed Craftman model 315.24510 Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Router Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:


  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
10-01-2017 01:21 PM
Cherryville Chuck We've seen a few people who had this problem and I suggested the heat gun too but one member didn't have one and tried a hair dryer instead and he said that worked too. All the complaints I had seen so far were with routers that had sat for quite a while. I wasn't aware that it could be an ongoing problem.
10-01-2017 12:05 PM
Stick486 great post...
instead of baby talc use dry-lube...

10-01-2017 11:36 AM
Riko LeChien
Jammed Craftman model 315.24510

I had a jammed bit height adjustment on a Craftman 315.24510 router and I fixed it.
The reason of the issue is not due to the wood dust but to a poor quality of the plastic of the red adjustment ring. After a time, on this model, the red plastic adjustment ring tend to shrink a bit, jamming on the motor case. There will be no more bit height adjustment unless you do the following.

Here is how to fix the issue:

1) remove the small clear plastic protection cover.
2) hold your router by this opening on a bench vise.
3) carefully heat the red plastic ring with a paint remover heating gun. This will slack the ring enough to turn easily.
4) turn all the way out the motor housing, Don't forget to push in the shaft bit locking pin when removing.
5) to remove the adjustment ring from the router frame, you will have to find the beginning of the sma?l locking plastic O'ring (inside the big ring) and pull it out with a long nose plier.
6) you will now be able to remove the adjustment ring and fixe it on a lathe to sand the inner of the ring. Sand very softly (120 grit)
7) also use a small metal file to polish the plastic joint of the outher of motor case.
8) use baby powder (talc) on the housing and in the ring and re-assamble the router for an easier operation.

If the ring is still hard to turn re-do the sanding of the inner of the red ring.

If doing so you saved your router, give me a "thank's".

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

For the best viewing experience please update your browser to Google Chrome