|Topic Review (Newest First)|
|06-27-2012 08:25 PM|
Originally Posted by mgmine View Post
|06-25-2012 02:55 AM|
A Circle Jig with Serious Radius Reach
Here is a simple homemade circle jig with 3-feet of radius reach. Makes quick work of the large arcing arch shape cuts especially where match up work is necessary. Just a thought...
|06-12-2012 09:44 AM|
If you can get the arches to reveal "perfectly" to the cabinet (piano hinges applied and door braced) then you can tweak the squares to fit. |
BTW, looks like a neat project.
|06-12-2012 08:17 AM|
|mgmine||using an Auto cad program you could make the arch then enlarge it or shrink it keeping the same proportions. Once you have the pattern you could lay it out on MDF and then make a template out of it. MLCS has door templates but I don't know if they would work for what you are trying.|
|06-11-2012 04:21 PM|
|jreid64||The doors are going to be split down the middle so that when they are open, it is basically what you see split down the middle. The doors will be joined at that center opening with a full length piano hinge and they will open like a bi-fold shutter towards the center to allow access. I had the spindles placed further back but the owner wanted them positioned there simply becasue she liked them better in that position. The top unit is built on top of a very old mantle she got at an estate sale. Thanks for the advice. Every little bit helps!|
|06-11-2012 04:06 PM|
I agree make up some templates, and you might consider making doors that have a lip on them, that way there is no concern about have them match the the opening exactly, (you won't see the gap) |
I was just wondering how is that door on the left side going to open with that post in the way?
|06-11-2012 03:19 PM|
I'd go with a pattern, MDF or ply. Work with the patterns till you get a good result, then use a router with a pattern following straight bit. You should get consistent results. You could hand route or use a table. |
|06-11-2012 01:36 PM|
Picture for clarification
This is the doors that were done by hand but the are not even between the door and the cabinet when you are up close.
|06-11-2012 01:19 PM|
Routing Arch Top Cabinet Doors
I am making some custom display cabinets for a friend of mine and they have requested that the stiles for the tops of the cabinet doors as well as the cabinets themselves be arch shaped. My stile width is 1 1/2". Basically I was thinking of setting up some sort of a circle jig to cut both the cabinet stile and the door stile out of at the same time. If necessary, I can post a picture. I tried free handing this with a jig saw then cleaning up the edges witha spindle sander but it is simply too mismatched to properly look good when the door closes into the arch cut out of the cabinet. I thought about cutting them both out of a piece of plywood but bear in mind that the doors are all glass with the exception of the 1 1/2" stile on all sides include the arch shaped piece at the top. I need to know what would be the best jig out there for this as I have numerous doors to build. Anyhelpt would be greatly appreciated. Some arches are 5 1/2" at the top (very small) to about 48" diameter at the top on the bigger stuff. Rockler has some decent jigs but I need something precise and accurate for duplication. Thanks guys!