Router Forums
October 2015

Hello Router Forums Member!

Welcome to the October 2015 edition of the RouterForums.com newsletter!

To start off this month, we have some great information from our friends at CUTECH TOOL. Click on the first link below to learn about their amazing products, and find out how you could WIN a New Cutech Bench Jointer!
As well, we've also collected a number of interesting posts from our community, including pics of a Home built Router Lift for Dewalt DW621 router and a look at a Cherry and bird's eye maple cabinet. After you've read all that, please click on the image to the right to head to CutechTool.com to check out their great products and promotions!

Enjoy the newsletter and be safe out there!

-Your RouterForums.com Staff

Read More >
 
Win a New Cutech Bench Jointer!
Are you looking for an affordable high-quality spiral cutterhead bench top planer, or jointer, that can deliver professional results?
Then look no further than CUTECH TOOL!
Please take a tour of our website at www.cutechtool.com where you can find detailed information on our products, our current promotions etc..
Please tell your woodworking friends about us. We are quite sure you will find a machine that fits your budget and your woodworking needs!
We are also very excited to offer a Giveaway to members. Click on below link to enter to win a New Cutech Bench Jointer. Enjoy it !!

Thank you!
The CUTECH Team
Too Many Clamps!
Hmmm...I guess you can have too many clamps!
Home built Router Lift for Dewalt DW621 router
Hello all. I have been needing to set up a router table with lift for a while now but have been thrown off by the cost of both tables and router lifts. At least with the lifts I can see a lot of engineering and machine work to justify the cost. The tables not so much.
Double feather board
This is the feather board I use for routing raised panels with a vertical bit on the table.
Cherry and bird's eye maple cabinet
Here is a cabinet I finished a short time ago for book storage. It is my own design, but pretty standard as far as cabinets go. The door panels are bird's eye maple with the rest cherry. The top is my first breadboard end effort. I like the look of the ends standing proud so I did them that way. Three through dowels hold the ends in place. The centre one is tight whereas the two others are in slots for movement.
Dust collection - box vs Keen
I'm just wrapping up the router table build that I've been wanting to do for many years. It's time to decide on dust collection so I thought I'd get some opinions.
Heat and Routing
One reason to make cuts in 1/4" passes is because smaller routers cannot handle the work load the big boys can. Another reason is to allow time to evacuate the chips. Plunge routers have turrets for controlled cut depths.
Fireplace Mantle Build
Mantle for the master BR with matching cabinets for the bath. These are maple since they will be painted and glazed.
Router Forums, a part of VerticalScope Inc.
111 Peter Street, Suite 700
Toronto, Ontario, Canada
M5V 2H1
Contact Us