Look closely this is used for edge work. There must be clearance for the cup underneath.
If I trim a circle of 3/4" plywood, say a 48" disk, I need lift the material a good 3" to 4"(or whatever this Oneida dust copllection cup measures in height) off the table or more for this to work.
If your template work allows for this clearance then yes, very little if any of my template will allow for this type clearance, but then the regular dust collection on the router works very well, only when on edge do any of my routers release any major amount of dust, if any at all.
Last edited by dovetail_65; 08-31-2017 at 08:07 PM.