My first post of my projects
I've been on this forum for a while and never posted of what I've been doing so here goes.
Firstly I built a garage (hereafter known as the workshop) side door, sadly it's not 100 pc visible so no photo of it but it's a lot better than the one that was falling apart.
Then I decided to try and clear the workshop to panel the walls and try to keep it a little warmer. So I built a timber rack. The doors are held back until I get a bolt for the top but that's not the priority here as it's gonna get cold soon.
Decided I needed a TS sled, so built one. The plans for this one are all over the web but I did add a 3" plastic cover over where the blade runs and, as you can see in the second TSSled pic, it also covers where the blade comes through the fence so fingers should remain attached.
The 3rd TSSled image is the angle fence. I have 2 of them, one for each side, and they have slots on the top for hold downs to run in.
I have heeded the voices of this forum and made a couple of push sticks so fingers remain attached, the first is a 3/4" one and the second is about 1 3/4" with removeable handle from the shopnotes magazines.
Then I decided to build a rack for my G Clamps which, once the panelling of the walls is complete, will sit on a french cleat system.