MLCS cast iron ext wing
Has anyone had experience with this extension wing. I took a leap of faith and got one from amazon. It just arrived and looks solid and well machined.
It is intended to mount on my Unisaw (with the addition of another 10" extension to the right of the blade.
My problem is that it has only 8" of table top space between the edge and the router spindle. In that 8" is the miter slot. Seems a bit short and that some workpiece won't have much to ride on. My old bosch table has 12". I am planning construction of 30 or so raised panel doors/drawer fronts and am worried the panels will rock.
Any feedback is greatly appreciated as this guy was expensive and if it's not better than sliced bread it's going back.