Using DW625 In New Table
New to the forums and hoping to get some guidance here.
I'm pretty new to woodworking, and have just started getting into router work. I acquired a DW625 off ebay, and used it for some freehand work on a armoire I've been building. My original intent was to just order the doors for the armoire, but after some reflection, that just seems wrong. So, now I'm committed to building a router table and mounting my DW625 to make raised panel doors for this project.
I've read several reviews here about doing this with the DW625, but I'm not sure how to proceed. It sounds as if the springs and brass tubes have to be removed from router to properly mount it. Is this correct, and if so, how does one go about this? Also, I've seen suggestions that the Woodpecker mounting plate may be the way to go. Any thoughts on this subject? I'm assuming any plate drilled for the DW621 will work interchangeably.
Any other thoughts or guidance the group can offer would be greatly appreciated.