Yes, that is the one. Free shipping in USA. You will have to drill and tap 4 (four) holes, 2 (two) in the lift itself and 2 (two) in router plate. Some people say that you could use double face tape. I tried that first (the easiest method to be used first) and found that tape being flexible, the responsiveness of the readout and repeatability was not up to snuff. Once I mounted it with screws, it worked flawlessly. No more height gauge or caliper. What a time saver, not to mention errors. My fence is based on Freud SH-5 with independent adjustment of in and out fence to within .001". It works great as a joiner as well. I am thinking of adding same digital display to each of the fence so I wont have to remember the amount of revolutions (each is .050") I made.