Another topic of router table fence
I finished my router table and start to think of the fence now. After reading a lot of good replies from another thread, I plan to order the ' 24" Pre-Drilled and Slotted Router Table Fence with Opening' from ptreeusa, then attach a MDF.
My question is I don't have any T-track on my table. Can I just use two clamps to hold the L-fence for router? Thanks.
Is it difficult to make two T-tracks? I guess it requires a specific router bit and accurate cut? I don't want to buy another bit and just use it once. With my current tools, I doubt I can cut a straight, accurate T-track.
Last edited by volunteers; 06-28-2011 at 12:33 PM.