I am sorry for My mistake! I destroyed My message! I wanted to respond to the message where You were wanted to purchase a pattern for the mount, or bolt layout! That can be accomplished by taking the bottom plate from Your router. That plastic "phenolic plate" is the only pattern You will need! It gives You the bolt, and bit opening dimensions. Be sure to very carefully lay out the center hole, and if You are troubled by that, use a 1/2 in. drill bit with a nice sharp center point. Chuck it into Your router, and turn by hand on Your finished plate that Your making. This way, You are assured of a very accurate centered hole! I an not sure if the router tables are identical, nut I hope this part gives You a little help. Again, Sorry for My making My 1st. reply disappear! And Happy route- ring!
John 3:16 Please fill out your profile, It helps us to know you better