
| LinkBack | Thread Tools | Display Modes |


I was reading about these non-metallic base plates can start to "dish" over time from having a heavy router hanging from it continuously. Is this something to look out for with the material OP uses? Should I remove my router from the table when not in use to remove the stress on the base plate?
Sponsored Links | |||
Advertisement | |

I haven't had any problem with mine yet. They are guaranteed not to sag so based on that if mine ever does I expect I will be getting a replacement from them. 
Corey

Corey
Retired Moderator



As thick as OP's plates are and considering the material they are made of, there shouldn't ever be a problem of them sagging.
I don't know how long Corey has had his but, I'm going on 2yrs without any problems.
I don't know how long Corey has had his but, I'm going on 2yrs without any problems.
Ken
***Please fill in your profile, at least your location. As this will help us help you better.***
"A VETERAN"
"Whether active duty, retired, national guard or reserve - is someone who, at one point in their life, wrote a blank check made payable to "The United States of America", for an amount of "up to and including my life". That is HONOR, and there are way too many people in this country who no longer understand it." -Author Unknown
Sponsored Links | |||
Advertisement | |

6 months for me Ken and glad to know that you are touble free at 24 months. I don't expect any problems.
Corey
Corey
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Show Printable Version Show Printable Version Email this Page Email this Page | |
Display Modes | |
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Guide Bushings for Oak Park Base Plate | Jim B | General Routing | 5 | 12-07-2005 10:39 AM |
Hitachi m12vc sub base question | Cactus Carl | General Routing | 4 | 09-12-2005 09:29 AM |
sub base and base plates | 46_trap | Jigs and Fixtures | 0 | 05-23-2005 03:39 PM |
Question: Sub Base Plate and guide bushings | 46_trap | General Routing | 3 | 04-17-2005 08:25 PM |
good source for base plates? | billtvt | Jigs and Fixtures | 3 | 03-05-2005 10:16 PM |
Posting Rules | |