Router Forums banner
bench top
1-3 of 3 Results
  1. Tools and Woodworking
    I purchased an old Record 52 (made in England model) to fit to my about to be constructed workbench, and although am basing my workbench on some plans from a book, can't figure out how to attach the vice to the bench. The instructions re the vice in that guide are very vague, to say the least...
  2. Table-mounted Routing
    I was already to buy the Bosch Bench Router Table (RA1181) when I finally got a copy of "Router Joinery Workshop" by Carol Reed. I really liked her design, and for the first time thought, "I could build that!" I am surprised I haven't found much about the router table design on this or other...
  3. General Routing
    while attempting to use an upcut spiral bit to route 3/4 inch dogholes in a bench top, i'm having problems with the bit binding and creating quite a mess. are there any tricks to this?
1-3 of 3 Results
Top