Router Forums banner

box joint jig

  1. Jigs and Fixtures
    Have thought about doing one of these for a while. Had some time between projects so gave it a try. Fingers are all 1/2" wide. Worked great and only required light mallet taps to make the fit. Had on chip out issue but I did not score the cut line and pushed the router a little to hard/fast...
  2. Jigs and Fixtures
    I made a box joint jig per the plans on the Internet, and found that the jig was very accurate, in spite of the poor quality of my attempt…… I then went to my model “2”. I found modifications that really worked well. I have attached photos of the model “2” with a sample “box” made with all sides...
  3. Tools and Woodworking
    There has been previous discussions concerning the Incra I-B Jig for box Joints. Recently, I have run across another jig (Woodhaven 4555 Box Joint Jig by Woodhaven. The cost of this jig is $65 at Amazon. The Ibox Jig is $144 right now at Amazon. Has any one used both. It looks like they...
  4. Jigs and Fixtures
    I managed to make this jig over the holidays, using some birch plywood, using this tutorial. The results are pretty nice, though it's somewhat laborious to clamp and unclamp for each cut, I think this would be better if I got some nicer fast clamps. I think I might extend the fence to do...
Top