Router Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-4 of 4 Results
  1. CNC Routing
    Hello everyone, I've had a 3018pro for a little over a week now. I was able to sucessfully carve a few things. I haven't changed any settings and now I am having issues. I am attempting to cut out someone's family name, it seems to start off fine but then somewhere along the way things go wrong...
  2. CNC Routing
    Hi folks, I built my first grbl engraver today, from a kit on Amazon. Its firmware is 1.1. Working with the gcode below, which looks ok on ncviewer.com, I can't get Candle to run the lines correctly. If I copy and paste each line into TeraTerm one at a time, and wait for one command to...
  3. CNC Routing
    I am thinking of getting a small CNC miller, but have no experience of them at all - although I do have experience of machine tools in general. What I want it for is milling carbon fibre sheet for quadcopter parts - just for myself, not professionally. The one that gets talked about a lot is...
  4. CNC Routing
    I purchased limit switches and I installed the limit switches and plugged them into my Woodpecker CamXtool V3.1 controller board and did the necessary changes in the controller software. The switched works when they are pressed and a little green light comes on. The issue is however that the X...
1-4 of 4 Results
Top