Router Forums banner

cutting board finish

  1. Show N' Tell
    Here is a picture of the 3 cutting boards I made for Christmas Gifts. The cutting boards are made of 5/4 Hard Maple and 5/4 Walnut. I ripped these into 3/4" wide strips 15" long and alternated the hardwood. After the glue up had dried and cured, I cross cut two additional strips 3/4" wide at...
  2. New Member Introductions
    Hi everyone. I live about an hour north of Toronto in Ontario, Canada. I make cherrywood placemats as end cuts. They are about 17" X 14"X 1/2 " thick. I am starting to make cherrywoood cutting boards and am searching for the right kind of finishing oil. I was going to use pure tung oil but...
Top