Router Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. Show N' Tell
    Here is a picture of the 3 cutting boards I made for Christmas Gifts. The cutting boards are made of 5/4 Hard Maple and 5/4 Walnut. I ripped these into 3/4" wide strips 15" long and alternated the hardwood. After the glue up had dried and cured, I cross cut two additional strips 3/4" wide at...
  2. Show N' Tell
    This is my first post on this web site. Hope you like the work. Cutting Board is made from Purpleheart, Hard Maple, and Walnut. Size approx. 12” x 18”. The hardest part of the project was the glue up. I had to apply the glue to each individually piece. My saving grace was the glue up jig that I...
  3. Workshop Showroom
    New eco friendly cherrywood cross cut cheese board finished with 12 coats of cold pressed 100 % natural hemp seed oil and natural beeswax
  4. Show N' Tell
    Hi yall. I wanted to show a couple things I gave out for Christmas. Of course the cutting board is always on somebodies wish list. It is made of purple heart and yellow heart and finished in mineral oil and paraffin wax. Every time I make one it gets easier. The chess board I also made for...
  5. New Member Introductions
    Hi All, I am new to outerforums, and moderately new to routers. I have been working with wood for a long time, but haven't done much with routers, as they have always seemed tricky to work with. But I bought a couple of books and have done some reading, and recently I used a router table to...
  6. General Routing
    Greetings to the woodworkers on this forum. I live in Victoria BC and I make stuff in little bits of spare time. I use a lot of pallet wood. Right now I'm making a new cutting board for our kitchen out of pallet oak. I am trying to figure out how to make the little groove around the edge...
1-6 of 6 Results