Router Forums banner

dado jigs

  1. Jigs and Fixtures
    Okay, it's a few years old now, but here is my variation of a dado jig for routers. It relies on pattern bits. You can use whichever size meets your needs. While it shares much in common with others dado jigs, I believe my modifications to the general design make it easier and quicker to use...
  2. Jigs and Fixtures
    Hi Just completed my router dado jig. Made it out of what I had to spare - 12mm ply, pine and Tasmanian oak. I made the far end flush so it can sit on a wider surface - maximum length of the dado is about 810 mm and maximum width 54 mm using a 8mm router bit. Knobs are on top and the two stops...
  3. Jigs and Fixtures
    I want to cut 1/4 inch deep 1/4 inch wide and 3 inches long dados at regular intervals in a 3-1/4 inch wide board cross grain. The boards form the vertical sidies of of a shot glass case and the dato slots are the support for horizontal shelves. These slots have to be precisely spaced at 2-5/8...
  4. General Routing
    I want to cut 1/4 inch deep 1/4 inch wide and 3 inches long dados at regular intervals in a 3-1/4 inch wide board cross grain. The boards form the vertical sidies of of a shot glass case and the dato slots are the support for horizontal shelves. These slots have to be precisely spaced at 2-5/8...
Top