Router Forums banner
depth adjust

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-4 of 4 Results
  1. Starting Off
    This question is open to all who can help me out. I have a Wolfcraft table and a Bosch 1617 EVS router. ( The plate is about 3/4" thickness) When I install a bit it doesn't extend above the table far enough. I was told that I could put a 1/2" dowel and a 1/2" rubber grommet to raise the bit up...
  2. New Member Introductions
    I'm cutting small cross halving joints in wooden slats 6mm deep and need to make fine adjustments to the cutter depth. The depth gage on my Makita 3620 is too crude to be of much use. I've not had much experience with a router before. Any suggestions appreciated. The same question applies to...
  3. General Routing
    I have a sears 2 Hp Router mdl 315.269210. The depth adjusting mechanism is a cylinder housing with spiral grooves and a series of adjustment rings, one of which has the mating tread that, when rotated, causes the cylinder to move up or down - thus adjusting the height of the cut (all...
  4. General Routing
    Hello all, I have been in the sign industry for 15 years and have been using a router for the past 10 years. I use a gerber sabre router 408 and a milwalkie hand router. My gerber sabre 408 CNC router is not routering all the way thru the substrate. It is as if I am using too thick of a...
1-4 of 4 Results