Router Forums banner

depth of cut

  1. Jigs and Fixtures
    I am in the process of making a couple of drawers with my Incra fence using 3/4" wood. Before I start making test cuts, etc any thoughts, suggestions, do/don'ts, etc I should consider before I actual get going, especially concerning "depth of cut". I am relatively new at this. Thanks
  2. Table-mounted Routing
    I just got a new router table which is a cast iron attachment to my table saw. Yesterday I was routing some 3/4" maple, making some moulding for a project and the router seemed to chatter as I fed it through. I have a 3.25 hp Triten router mounted underneath the table. I was feeding from right...
Top