Router Forums banner

feed rate

  1. Table-mounted Routing
    I just got a new router table which is a cast iron attachment to my table saw. Yesterday I was routing some 3/4" maple, making some moulding for a project and the router seemed to chatter as I fed it through. I have a 3.25 hp Triten router mounted underneath the table. I was feeding from right...
  2. Router Bits - Types and Usage
    Hi all, I have just started working with router and after doing only short flush trimmings I found that router bit, collet/chuck and whole drive end of the router is very hot. Between the runs I had to leave it for at least 15 minutes to cool down. Ambient temperature of 35°C is not helping in...
Top