Router Forums banner
finger joint
1-3 of 3 Results
  1. Router Bits - Types and Usage
    Hello everyone, this is my first post here. I am working on a small living room project that involves joining one foot sections of poplar to make a long piece of trim that I will use as a baseboard. I decided to go with the Rockler finger joint bit 1-3/8" Dia x 1-1/2" H x 1/2" shank part number...
  2. Table-mounted Routing
    I experience a lot of frustration attempting to make good finger joints (box joints) on my router table. I have a shop made jig which allows me to cut good sizes and fits, but I can't get away from alot of tearout on the back side of the cut. Any suggestions?
  3. Table-mounted Routing
    Does anyone have any good plans for a Finger Joint jig for use on a router jig?:fie:
1-3 of 3 Results
Top