Router Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results
  1. Table-mounted Routing
    Hi everyone- I recently picked up a router table top, and there is a .022" inch dip in the table top (measured with straight edge and feeler gauge across longer width portion of table). If I flip the table over, the bottom side has a corresponding crown in the same spots. Is this flat enough...
  2. Table-mounted Routing
    Hi, I'm new to this forum…and am just in the process of building a new router table out of 25mm MDF with a Kreg plate. I'm working on the flatness of the table and smoothing out any bumps but how flat is flat enough? The table is 1000mm x 500mm or so. Many thanks for any help. James
1-2 of 2 Results