Router Forums banner
flush trim
1-4 of 4 Results
  1. New Member Introductions
    Hi all! I'm new to this forum ad joined to get some ideas on a problem I have. I am too new to post pictures, but I would be happy to email some to someone if you need to see them. I took on a job that I can't figure out...high end motor home. The cabinet doors have a PSA burl maple veneer just...
  2. Table-mounted Routing
    Hi folks. Glad to be among experts. I didn't know you post in categories, so I posted my question today under Introductions. Am re-posting under table-mounted routing as I should have done at first. My question: I've glued 1/4 inch thick strips of 7/8 wide oak to the front and back edges of...
  3. Guide Bushings and Templates
    I've looked everywhere my search engine took me for flush trim or pattern cutting router bits and I can't seem to find the size I need. :( Top bearing, 1/4 " Dia. 3/4" long flush trim 1/4" or 1/2" shank preferably carbide tipped or solid carbide. The corners on the template for most guitar...
1-4 of 4 Results
Top