Router Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results
  1. CNC Routing
    Hi folks, I built my first grbl engraver today, from a kit on Amazon. Its firmware is 1.1. Working with the gcode below, which looks ok on, I can't get Candle to run the lines correctly. If I copy and paste each line into TeraTerm one at a time, and wait for one command to...
  2. CNC Routing
    i have these motors: This controller board: And a 24v, 5a power supply. I am using Grblcontrol(Candle_1.1.7...
1-2 of 2 Results