Router Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-4 of 4 Results
  1. New Member Introductions
    Hello forum team, I am in the middle of designing a project that includes a sliding Tambour door, using specialty router bits. I need help in routing out a curved groove for the tambour door to slide in. If some one from the forum can provide some insight, it would bring one step closer in my...
  2. General Routing
    I am planning to rout grooves in some 6 mm thick MDF, and then I will paint it. And I hope it then looks like T and G boarding. I am wondering what the best type of router bit is for this job, and whether there are any special techniques which I should know about. Thanks for any help, David
  3. New Member Introductions
    Hi All, I am new to outerforums, and moderately new to routers. I have been working with wood for a long time, but haven't done much with routers, as they have always seemed tricky to work with. But I bought a couple of books and have done some reading, and recently I used a router table to...
  4. Starting Off
    Hello everyone, I need help with plunging grooves with my plunge router on top of a flat board which is approximately 6" wide X 12" long. I would like to make the indentations (grooves) about 2 inches by two inches wide, but only about 1/2" deep, with a 3/4" round bull nose router bit. I...
1-4 of 4 Results