Router Forums banner
half blind dovetails
1-4 of 4 Results
  1. Table-mounted Routing
    I ran into a little problem (two, actually) when cutting half-blind dovetails on my new INCRA LS-25 Wonder Fence System. Other components in use with my LS-25 include: Incra Mast-R-Lift II router lift, Porter-Cable 75182 router, Whiteside router bits (D14-55 1/2" x 14 degrees dovetail bit, in...
  2. Jigs and Fixtures
    I ran into a little problem (two, actually) when cutting half-blind dovetails on my new INCRA LS-25 Wonder Fence System. Other components in use with my LS-25 include: Incra Mast-R-Lift II router lift, Porter-Cable 75182 router, Whiteside router bits (D14-55 1/2" x 14 degrees dovetail bit, in...
  3. Jigs and Fixtures
    I am having trouble with the setup, on my Omnijig Model 7116, for making 1/4 inch half blind dovetails in 3/8 inch wood. The specs in the manual are for 1/2 inch wood. Anyone have any experience in using 3/8 inch wood?
  4. New Member Introductions
    Hello - I am new to this forum. I am an amature woodworker with a few years of experience. Most of the projects that I have made in the past are of Shaker origen. I am looking for information on how to setup an Omnijig 7116 for 3/8 inch wood using a 1/4 inch half blind dovetail templet. Any...
1-4 of 4 Results
Top