Router Forums banner
jigs & fixtures
1-5 of 5 Results
  1. Jigs and Fixtures
    Have I set up the Ultralite correctly? The instructions said that the fence should be to the right. It also shows that the clamp is on the other side of the operator. My question is that it looks to me like the project would be pushed so that the rotation of the bit would tend to push the board...
  2. Table-mounted Routing
    I would appreciate some help. I’m relatively new to routing and my learning curve over the past month has been pretty steep- thanks mostly to reading posts on this forum. I’m on my fourth version of a coping sled. It’s about ready to actually test/use, but before I muck it up I need some...
  3. Jigs and Fixtures
    I am in the process of building a chest of drawers for SWMBO.... I have finished the dust frames and put dadoes and rebates into the side of the ply. Then I decided that Ply was a poor choice so went out and bought some Jarah veneered MDF. I also decied that I wanted to make my mistakes on...
  4. Jigs and Fixtures
    Hi all, I'm a novice woodworker and want to start dovetailing. I saw on eBay a PC 4210 & a 4212 for about the same price. which one would you guys recommend? I'm leaning towards the 4212, but would appreciate your expert opinions. Thank you!
  5. Jigs and Fixtures
    Has anyone seen or perhaps even made a jig that can cut threads in a wooden dowel? I recall seeing a book about routers jigs over a year ago that showed how this could be done but have not been able to located the book again.
1-5 of 5 Results
Top