Router Forums banner
miter slot
1-4 of 4 Results
  1. Table-mounted Routing
    This is my first post here, hope it makes sense to somebody besides myself! I was given a JET Xacta Lift recently new in the box so I decided to build myself a table for my garage/shop... Problem I'm seeing is that this lift/insert is designed differently than most any other I have seen, rather...
  2. Table-mounted Routing
    I'm building a new top for my touter table. Does anyone have any suggestions/preferences for a miter slot vs just using a dedicated sled. I've been using a sled with great results. I don't see how a miter slot is useful as I almost always use a fence for dust collection.
  3. Table-mounted Routing
    I'm finishing my router table extension for my table saw, and seek advice about the following: My saw is a Grizzly G05444Z with a standard rail. Thus, the table is 27" wide and approximately 18" deep. See images below. 1) Any advantages to a separate fence as opposed to clamping an accessory...
  4. Jigs and Fixtures
    Hey there! Been posting on Woodnet for a while, saw ya'll over here talking about routers and thought I'd chime in. I'm looking for advice on making a new router sled. I ordered an Incra 18 inch miter slot runner from Amazon, hoping to make a sled with the runner (instead of just butted against...
1-4 of 4 Results
Top