Router Forums banner
mounting plate
1-4 of 4 Results
  1. DeWalt
    I am mounting a DW625E into a router table. The table instructions for the insert advise using the screws from the factory baseplate (or purchasing longer ones). However, removing the baseplate shows that there are 3 other M6 threaded holes in addition to the 6 M4 holes for the existing...
  2. Table-mounted Routing
    I am new to the forum and have a fairly complete shop. I am restoring a 100 year old house on the National Registry. I just finished the qtr. sawn oak kitchen cabinets using Sommerfelds tongue & groove methods in shaker styling. My Freud / Incra LS17 Table router got quite the workout and has...
  3. Tools and Woodworking
    New to this good site for information. I am making a table saw router table extension - will post images later - but for now have a question. Can anyone confirm the actual (as opposed to nominal) dimensions of the Rockler 1/4" mounting plate? The catalog states 8-1/4" x 11-3/4" but the template...
  4. Table-mounted Routing
    Hi all, A few months back I purchased a Bosch router table (RA1171). Impulse buy. I had been looking at routers on amazon and was attracted to the Freud FT3000VCE 3-1/4-HP. High rating and 5 year warranty. However it is not listed in the manual as compatible with the included table plate...
1-4 of 4 Results
Top