Router Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-3 of 3 Results
  1. New Member Introductions
    I am William and I don't know what I've done just yet but having done a lot of reading about routers took the plunge (excuse the pun!) yesterday and bought a Freud FT1700 which included a table. Now the challenge is to assemble it and get on line to listen to all on this forum to learn how to...
  2. General Routing
    while attempting to use an upcut spiral bit to route 3/4 inch dogholes in a bench top, i'm having problems with the bit binding and creating quite a mess. are there any tricks to this?
  3. Starting Off
    Hello everyone, I need help with plunging grooves with my plunge router on top of a flat board which is approximately 6" wide X 12" long. I would like to make the indentations (grooves) about 2 inches by two inches wide, but only about 1/2" deep, with a 3/4" round bull nose router bit. I...
1-3 of 3 Results