Router Forums banner
rockler
1-9 of 9 Results
  1. Router Bits - Types and Usage
    Hello everyone, this is my first post here. I am working on a small living room project that involves joining one foot sections of poplar to make a long piece of trim that I will use as a baseboard. I decided to go with the Rockler finger joint bit 1-3/8" Dia x 1-1/2" H x 1/2" shank part number...
  2. Table-mounted Routing
    Hi! I am a beginning woodworker with a small handful of projects under my belt. I am in the middle of a wine rack/built in cabinet project now. After struggling with routing small pieces with my hand held router, I think I'm ready to get a router table. The Kreg precision router table, rockler...
  3. Table-mounted Routing
    Rockler Pro Phenolic Router Table, Fence, & Stand - Plus Lift Hi everyone! I have been thinking about getting a router table for a long time. Recently I received an email from Rockler.com about one of their router kits. I checked it out and came across this kit that includes a solid phenolic...
  4. Table-mounted Routing
    Found a router table on craigslist. It comes with a cabinet below but I just want the top. Seems like it has a plate installed and maybe a few inserts. I haven't gotten a response yet on whether it has a fence. They're asking $50 for the top...is it worth the money? Dask
  5. New Member Introductions
    Just found this forum and I have a Rockler dovetail question I have not been able to resolve. Maybe I can find an answer here, I am going to the jigs forum and try to find a suitable thread.:fie:
  6. Table-mounted Routing
    Let me apologize in advance as I am sure this has been covered elsewhere. You can probably tell I am a newbie to this forum. Years ago I built a router table and though it has served me well it is strictly utilitarian and a little clunky. So it is time for a new one. Has anyone had experience...
  7. Jigs and Fixtures
    I have a Rockler dovetail jig that I'll be using to make the drawers for my kitchen. Had some fun with it last week, cutting up some old 1/2" plywood. Whilst using the jig, I noticed the plywood was chipping and splintering in some cases - which I'm almost positive was a result of how old and...
  8. Tools and Woodworking
    I had a Grizzly G1029Z 2 HP Dust Collector in my old shop, but am unable to use it right now due to a lack of 220 volt power in my detached shop, and a likelihood that I will not be able to come up with the $$$ to get 220 out there for some time. With 1550 CFM, the old Grizzly workhorse did a...
  9. Jigs and Fixtures
    any suggestions to a new user setting up a model 22818 complete dovetail jig for half dovetails....using a Porter Cable 895pk router
1-9 of 9 Results
Top