Router Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 6 Results
  1. Portable Routing
    I have a Ridgid 5.5 Amp Corded Fixed Base Trim Router that come with 2 router plates with homedepot purchase. However, my 1/2 inch rounding bit doesn't fit in the openings of those plates. Has anyone run into this problem before and where can I find a clear plate that would fit bigger bits?
  2. New Member Introductions
    This is a combo introduction/question. Hope that's OK! I'm getting back into woodworking after a lengthy absence. Not that I was very advanced before. I like having a workshop and tools so I can fix things and occasionally make something, but I have so many other interests, I don't get enough...
  3. Table-mounted Routing
    Been gone too long. I recently got a Ryobi BT3000 tablesaw setup with extension table, blades, etc. When I got it home I noticed a hole with four smaller holes surrounding it in one of the sliding panels. I looked at the manual (real men read manuals!). It is for a router! Router is a Skil...
  4. General Routing
    Hello all... I found my way to this site via a search for information re a drilling template for the Triton 3 1/4hp TRC001 Router. I bought a Woodpeckers plate that fits the PC 7518. Although the 4 screw holes line up, the hole for the height winder does not. I chose the Triton for a number...
  5. Table-mounted Routing
    Hi Folks, I'm new to the forum. I recently purchased a Triton TRA001 with the intention of mounting in a shop made router table. I'm in the market for a router plate that will be inset in the table. I know the Woodpecker alunminium plate fits this model router, but does anyone know of any...
1-5 of 6 Results