Router Forums banner
shaper
1-8 of 8 Results
  1. New Member Introductions
    I have a friend who gave me a kufo shaper SK-28sp. It has a 1” spindle with a thread pitch of about #12. As far as I can tell. It is an earlier model that has a fixed position for the spindle. I’m missing the spindle nut, throat plate and would love to find a service or owners manual for. Any...
  2. New Member Introductions
    Looks like a great forum. Look forward to meeting some folks. Just purchased a Rockwell shaper 43-120 with no belt and the motor not attached so I hope somebody has a manuel.
  3. Table-mounted Routing
    I am in the middle of a conversion that is going very well. I am altering a large, old and damaged 3hp Grizzly shaper into a router table. The cabinet, cast iron top, the spindle "elevator" and the fence are being saved. The original motor, motor mount, belt-drive and spindle are being removed...
  4. Tools and Woodworking
    I'm looking for a manual for a Rockwell T100 Wood Shaper. When I look throught the list of manuals, I do not see Rockwell listed. Serial # 159581 This is a much older model, runs ok, but I want to get the most use out of it. Any help or suggestions would be appreciated. Thanks!
  5. New Member Introductions
    Hello from San Antonio, Texas. I am an aspiring wood worker hobbyist and I desperately need advice on a starter router table. I have a $99 Ryobi combo job that my neighbor gave me ( after he bought the $600 Kreg setup) but I now have a Bosch 2 1/4 plunge/ stationary base combo and would like to...
  6. General Routing
    Hello all, Does anyone know where I can get a 1/2" Shaper Spindle Router Collet for my Grizzly G1024 shaper? The original 1/2" spindle is still in tact. I am thinking this would save me from buying/ building a router table and another router. Tech support at Grizzly says it is a discontinued...
  7. Table-mounted Routing
    I'm a new member to the forum. I have the opportunity to purchase a Grizzly G1035 1 ½ HP Shaper for $350 including the Router Spindle Attachment. Two speeds – 7000 & 10,000 rpm. Questions: 1. What can I do with a router table that I cannot do with a shaper or what limitations does a shaper...
  8. Tools and Woodworking
    I need to upgrade and add some tools in my shop. I currently have a small tabletop router table and misc hand held units for most applications, but want to get a larger more permanent mounted router station and or shaper. My question is what is the best system out there for a router...
1-8 of 8 Results
Top