Router Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 3 Results
  1. General Routing
    New kid here. Looks like a great forum! I need to cut a 3/16" 45 degree angled slot along the length of a 4" by 26" by 3/4 piece of oak. The slot is located approximately 1" in from the long edge and runs the length of that edge. Slot goes all the way from edge to edge, so can be done without a...
  2. Jigs and Fixtures
    I have several 5 gal. plastic buckets with a tight fitting plastic lids that I want to remove. The lids are not the typical vertical slots that you just break open to pry the lid off so I need another approach. I tried cutting my own slots but that is extremely labor intensive and messy (I have...
1-2 of 3 Results