Router Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results
  1. Jigs and Fixtures
    I'm interested in making a magnetic featherboard/stop that will work on my steel tool tops. It looks like rare-earth magnets are the way to go but how big should the magnet be to safely remain attached to the table if placed under stress. I see that you can buy some magnets with holes for screws...
  2. Starting Off
    Hello everyone, I need help with plunging grooves with my plunge router on top of a flat board which is approximately 6" wide X 12" long. I would like to make the indentations (grooves) about 2 inches by two inches wide, but only about 1/2" deep, with a 3/4" round bull nose router bit. I...
1-2 of 2 Results