Router Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. Table-mounted Routing
    Can anybody recommend a table saw attachment for my 3HP RYOBI router or should I just build a dedicated router table? The insert would go in a Delta Shopmaster tablesaw.
  2. Table-mounted Routing
    Hi all. I'm researching plans for a router extension for my Jet contractor's saw and am not sure if I need to provide extra support, ie legs, to help bear the weight of a Makita 3612 in a 10" x 14" metal plate...heavy! My shop is small and my saw is on casters, so I'm not sure how I could make...
  3. Table-mounted Routing
    Hi: I'm new here today. In fact, I initially accidentally put this question up on the Introduction forum, so I decided to copy and paste it here. The question pertains directly to my router table, but it is more directly tied to issues of dust collection, and I recognize it's come out a bit...
  4. Table-mounted Routing
    Hi All first post looking for some ideas and opinions. Am looking to build a DIY router extension to my Jet JPS 10 table saw. I have an offcut laminated 30mm tabletop which I plan to use for the extension plus a drop in router insert from Incra. Was going to remove the entire right cast iron...
  5. Table-mounted Routing
    I'm building a tablesaw extension from a found piece of 3/4" melamine (Ikea scrap $3). The extension is 27" deep by 28" wide. I've framed it with 3/4" x 4" poplar. As I was building it - I realized I could mod it for use as a router table. I'm wondering if I should be concerned if the...
1-5 of 5 Results