Router Forums banner
tables
1-3 of 3 Results
  1. Tools and Woodworking
    I want to make table tops from left over 2"x 10" pine. I made an initial test one by squaring each side; then planning them to 1.25"(this was the width that allowed me to remove the board warp);then I routed a finger joint full length;glued and clamped together. When clamping together I also...
  2. New Member Introductions
    Hello everyone, My name is John and I am a hobbyist woodworker in Houston, TX. My projects have mostly been jewelry boxes and small to medium furniture such as tables, wall shelf units, etc. I hope to get some good tips from the Router Forum, and possibly even contribute a few. Cheers!
  3. New Member Introductions
    hey, I'm 26 from memphis tn. I have been tossing the idea of woodworking around for a while just never had the money. so I saved up to get the miter saw, table saw and router with router table witch I got over the christmas weekend when they where on sale. I still got all the smaller power tools...
1-3 of 3 Results
Top