Router Forums banner
Cancel

Posts by JIMMIEM

Jump to Latest Follow
1 - 1 of 30 Posts
J

· Registered
Joined
·
936 Posts
Discussion Starter · #1 ·
I was glancing through an article on roundover bits and it mentioned using a 1/16" roundover bit to soften edges. I have usually done this with a just a fine sanding block. Should I get the 1/16" roundover bit for this?
 
1 - 1 of 30 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
About this Discussion
29 Replies
17 Participants
Last post:
subtleaccents
Router Forums
A forum community dedicated to router and woodworking professionals and enthusiasts. Come join the discussion about different types of routing and routers, shop safety, finishing, woodworking related topics, styles, tools, scales, reviews, accessories, classifieds, and more!
Full Forum Listing
Explore Our Forums
New Member Introductions Tools and Woodworking General Routing Table-mounted Routing Show N' Tell
Top