1/16" Round Over Bit

8174 Views 29 Replies 17 Participants Last post by subtleaccents, Dec 11, 2017

JIMMIEM

Discussion Starter · Nov 28, 2017

I was glancing through an article on roundover bits and it mentioned using a 1/16" roundover bit to soften edges. I have usually done this with a just a fine sanding block. Should I get the 1/16" roundover bit for this?

Save

1 - 1 of 30 Posts

chessnut2

· #24 · Nov 30, 2017

DesertRatTom said:
Sandpaper. By the time you have the bit set up, you'd have the job done. A tiny error in setting it up and you'd ruin the piece.

Both are good points, Tom.

Save

1 - 1 of 30 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.