Router Forums banner

1/2" collet and nut

1062 Views 2 Replies 3 Participants Last post by  Herb Stoops
I am in search of a 1/2" collet and nut for Craftsman router model 320.17543... have had no luck with online search.... any help?.....
1 - 3 of 3 Posts
Welcome to the forum,,,
I think if the nut is taken off and the 1/4" reducer is removed, the shaft is set up for 1/2" bits. If you have the nut it should work for both sizes, with the reducer, and with out.
Herb


https://www.manualslib.com/manual/496724/Craftsman-320-17543.html?page=3#manual


https://www.amazon.com/Craftsman-670345001-Original-Equipment-Manufacturer/dp/B00EFEPEHQ
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top