Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
55 Posts
Discussion Starter · #1 ·
Bob or Rick: Are there any 1/4" shaft router bits that are designed like the large molding bits that 1/2" shafts use? Are there rail and stile bits,raised panel bits etc? I am limited to a 1/4" collet. BY THE WAY,CLEAR OUT YOUR IN-BOX PLEASE!

Gary
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top