Router Forums banner
1 - 1 of 4 Posts

· Banned
666 Posts
normcatalunya said:
Hi all.
I have need to put a 1" rad on a Table edge.I have only 1/2" bit at the moment but don't seem to be able to find 1" rad?Is there one?
This cutter will be at least 2-1/2" in diameter check the of the opening on your router and I would also suggest that you only use this with a router with variable speed
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.