Router Forums banner
1 - 1 of 10 Posts

· Registered
253 Posts
The radius you choose may depend on your intended purpose. If you are just trying to soften a sharp edge so you don't scratch your hands, then use a radius smaller than half the thickness. My local woodworking club annually makes about 500 doll beds out of 1/2" Baltic Birch plywood and we use either 1/8" or 3/16" radius round over. This gives you a soft edge so that scratches are minimized.
1 - 1 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.