Router Forums banner
1 - 7 of 7 Posts

·
Registered
Joined
·
914 Posts
Discussion Starter · #1 ·
I need an inexpensive 3/4 Cove Router bit for a one-time project. I usually by premium bits but don't want to spend a lot on this one. Would prefer 1/2 inch shank.
I'll be using it on the router table so don't necessarily need a bearing on the bit.

Would appreciate recommendations. Thank You
 

·
Registered
Joined
·
914 Posts
Discussion Starter · #4 ·
I've been very satisfied with several "Yoniko" brand bits on E-Bay.
Router bits and a one-time project don't often go hand-in-hand.
Hi John,
Yonico didn't have a cove bit in the diameter that I need but they did have a box core bit in the diameter that I need. As I will be using it to cut an edge profile and using a router table and fence this should do exactly what I need. The Yonico bits got some really good reviews and the bit I got was very reasonably priced.
Thank You again for the tip.
 

·
Super Moderator
Joined
·
675 Posts
The very first "yellow bit" I bought years ago served me well (and still does) so I got others, then more, then more. So all of my out-dated (and unbranded) used up bits either get donated or tossed into a tupperware container for possible future use to be "repurposed".
Let us know how your project turns out !!
 

·
Registered
Joined
·
914 Posts
Discussion Starter · #7 ·
The very first "yellow bit" I bought years ago served me well (and still does) so I got others, then more, then more. So all of my out-dated (and unbranded) used up bits either get donated or tossed into a tupperware container for possible future use to be "repurposed".
Let us know how your project turns out !!
I got the Yonico bit and used it today. Did an excellent job.
Thanks again for recommending.
 
1 - 7 of 7 Posts
Top