Joined
·
3 Posts
Need Help!
Just installed new driver to Y axis . Now I have movement in all three axes where I did not before .However when first jogged machine moves in y axis but only one direction(was not moving previous new driver) X was moving two directions Z didn't try. I did a few checks on connections all seemed to be good connection, and now I have only movement in one direction in all three axes. Anyone out there that can make anymore sense of that then me? Using mach 3 and controller is Chinese CNC 4030Z. I will add a pic orginal driver and newly installed one.
![396402]()
![Electronics Technology Electronic device Finger Audio equipment]()
![Electronics Technology Electronic device Finger Audio equipment]()
Newly installed
![396403]()
![Electronics Technology Electronic device Finger Audio equipment]()
![Electronics Product Technology Electronic device Gadget]()
orginal
Just installed new driver to Y axis . Now I have movement in all three axes where I did not before .However when first jogged machine moves in y axis but only one direction(was not moving previous new driver) X was moving two directions Z didn't try. I did a few checks on connections all seemed to be good connection, and now I have only movement in one direction in all three axes. Anyone out there that can make anymore sense of that then me? Using mach 3 and controller is Chinese CNC 4030Z. I will add a pic orginal driver and newly installed one.
