Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
387 Posts
Hi: I had a PC router, a PC690, it isn't big enough for the raised panel cutters. I bought a PC7539, soft start varible speed to do the raised panels. The throat of the router should be big enough to acccomodate the large cutters. If you use a smaller router it is running to fast for those large bits, they should run 10K to 12K rpm.
Woodnut65
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top