Router Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
655 Posts
If you can't find a suitable bit, the easiest solution is to add a frame member to the inside. You can glue it and even add screws (from the inside - to hold while glue sets). If done right, you won't even notice it (unless you also used screws).

A spline joint could be done but it would be difficult to do with a 30° miter, especially on the large pieces you'd need for a pulpit.
 

Attachments

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top