Router Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hi all.
Been a bit stupid today and can't figure out how to program fusion 360 to cut a notch in a peice of 4 x 2 as pictured!
Rectangle Slope Font Parallel Screenshot


Can anybody tell me what tool path to use please?

Many thanks in advance

J
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #3 ·
Contour, assuming you're laying the board flat on your spoilboard and not on edge. You'll get a rounded inside corner, though, but that's to be expected.
Thanks David for that. When I select 2d contour, it wants to contour the whole piece! I have already got the 4" x 2" wood just need the notch taking out!
 
1 - 3 of 3 Posts
Top