[Ronald Reome]

Hi:I have a Probotix meteor with Linux,and Vectric Aspire software.I need a Post Processors for the 4th axes,wrapping on Linux,going from Y to A inch ngc. file,Does anyone have that file to download or where can I fined on line to down load?Thank Ron

 

[Ronald Reome]

we have it currently set up that way. However, it is wrapping around the cylinder the short distance rather than cutting the text along our stock the long way. So in short we are looking for the Y to A Linux post processor as we only have the X to A.
Having difficulties figuring out how to edit the X to A into the necessary Y to A post processor.
Any help or guidance would be appreciated.

Thanks

Ron

 

[Ronald Reome]

Thank you so very much for the quick response and the file. However we are having a problem with the file. When we use it it lays project on the table side to side instead of end to end on the rail side where router runs. Any ideas? is this mirroring like you were talking about?
Truly appreciate all of your help.
Ron

 

[Ronald Reome]

TO 4D
Here are two pics. One picture is of my table showing the 4th axis running front to back along the Right hand rail. The other is the error we got before searching for a YtoA Post Proccessor.
That error was ran with the X to A Post Proccessor and we got that error.
Hope you can help.

Ron

 

[Ronald Reome]

To 4D

That error msg since it cannot be scene very well is as follows

"The selected post processor wraps the x values and the toolpaths are being drawn with the Y values wrapped."

Thanks Ron

 

[Ronald Reome]

To 4D

I changed the Y to A file to a -A and it had no significant change in table view. I have attached a photo of what the terminal shows after touching down x,y,z and a. Any questions please don't hesitate to ask, as we are in the beginners stage of this journey.
Thanks Ron